Accurate and Repeatable High-Resolution EMC and EMI diagnostic with Hand held Near Field Probes on your on your lab-bench
Using Hand Held probes to identify and resolve EMC/EMI issue testing have never been this accurate and straight forward!
3D Precision Technology used to assist high density board designers to use off the shelf hand-held probes and visualise the root causes of potential EMC and EMI problems during pre and post EMC compliance testing.
EMProbe enables the PCB and Design Engineers to diagnose EMC/EMI problems using regular off the shelf hand-held probes. An easy to use Robotic Arm controls the movement of the probe to any direction and an external Spectrum Analyzer provides the results. The EMViewer software is used to control the Robotic Arm and the external Spectrum Analyser collects and analyse the results.
Different types of Robotic Arms can be used, based on the desired size and resolution.
Spectral scan, spatial scan, peak-hold, continuous scanning, spectral and spatial comparison, scripting, limit lines, report generation and notes.
Spectral Scan Time
11 seconds for L 10 cm x W 10 cm (L 4” x W 4”, 178 probes activated) from 10 MHz span to 110 MHz and 122 kHz RBW. Scanning area, span and RBW are user selectable within spectrum analyser specifications
Supported Operating Systems
Supported CAD Overlays
Picture in JPEG format
Standard Gerber© RS274x format and HPGL format CAD files
Spatial Scan Time
Continuous real-time for entire scan area (1,218 probes activated) when Level 1 selected: 5 sec.
Selected area 2.25 cm x 2.25 cm, 9 probes activated.
Level 1: <0.5 sec. | Level 2: 4 sec. | Level 3: 9 sec. | Level 4: 21 sec. | Level 5: 55 sec. | Level 6: 2 min 35 sec. | Level 7: 7 min 23 sec. | Level 8: 24 min 00 sec.
Base configuration = 150 kHz to 8 GHz
1,218 (42 x 29) H-field probes.
Level 1: 7.50 mm | Level 2: 3.75 mm | Level 3: 1.88 mm | Level 4: 0.94 mm
Level 5: 0.47 mm | level 6: 0.24 mm | Level 7: 0.12 mm | Level 8: 0.06 mm
L 31.6 cm x W 21.8 cm (L 12.44” x W 8.58”)
Peak marking accuracy of spectrum analyser
Calibrated before shipment. Firmware correction factors adjust for frequency dependent probe responses with +/- 3 dB accuracy
> 20 dB
10 W / 40 dBm
Anodized non-conductive metal
Glass Cover: 4kV DC; 2.6kV AC | Metal Case: 260V DC; 200V AC (measured as dielectric withstanding voltage – DWV)
From 15⁰ C to 40⁰ C
L 34.5 cm x W 43.5 cm x H 11 cm (L 13.58” x W 17.13” x H 4.33”)
12.70 Kg / 28 lb (including cables and the adaptor)
KeySight supported sa's
|Supported Spectrum Analyser: